Most kitchens have at least one or two shaded areas where more light would be of great benefit. Because the distance from the bottom of the cabinets to the counter top is less than 2 feet in most cases, you do not need lash a beacon under the cabinets. Generally a lower watt decorative fixture is what is required.
In some cases, you may simply choose an inexpensive single tube fluorescent fixture that can be plugged into a nearby receptacle. While these are cheap and install in minutes, you will lose some of your aesthetics if you choose this route. In an older home that is ready for a major kitchen upgrade, this type of fixture is a good choice for temporary lighting until the remodelling starts. To do this one, just buy the fixture at a local discount store, screw it into place, and plug it into the outlet. Turn on the switch, and the job is complete.
Now, for what most people think about when they desire some nice quality under-cabinet light. Since you want enough light to make a difference, steer away from rope lights or lights in tubes. These are great for accent lights above cabinets or in hidden recesses where the objective is ambience and not improved visibility.
For a modern or up-to-date look, small halogen fixtures are probably the best choice. Since you are retro-fitting the lighting, it is nearly impossible to hide the lighting the way it would be done in a new cabinet installation. You have to live with what you have installed already. Unless you are prepared to concede some of your interior cabinet space, you can write off recessed lighting.
This leaves you with two choices. You can buy some small fixtures designed to mount onto the wall surface. These may have adjustable focus points in the better models. The problem is that you may not have room between the upper and lower cabinets to install a fixture on the wall and still get enough light coverage on your counter top.
The second choice is to install the fixtures as a surface mount on the underside of the bottom of the upper cabinets. The good news at this point is that most kitchens are built with extra electric outlets around the back splash. This means you should not have problems finding an easy electric source near where you will be doing the installation. With a shorter wire run, it will make it easier to hide your wiring work to make the job look professional.
Since most of these lights are require relatively low amounts of electricity, you should not have to worry too much about overloading the circuitry. If you are installing multiple fixtures, you may want to check this out before starting the project. Turn off the electricity to the work area before opening up the outlet boxes. You may need to purchase “old construction” junction boxes to install switches next to the outlets depending on the type of fixtures that you have. Most places require switches to be installed on a ground and not a hot wire.
Begin the project by familiarizing yourself with the manufacturer’s installation guide. Next, clear off the entire counter where you will be working. Determine exactly where you desire the fixture to be placed. Set each fixture on the counter beneath where you intend to install it. Step back and decide where you will want to get the power for each light. It is best if you can adjust the placement so that there is not a stud between the power source and the light fixture.
With no stud to impede your work, you can run the wire up the inside of the wall and exit either inside the cabinet or just below the cabinet bottom. If you can exit inside the cabinet, run the wire along the sides of the cabinet to where you need it. Keep the wire from having to cross the shelf, and you will avoid future problems from the wire being in the way of the things stored in that cabinet. Inside the cabinet, you can make a slightly larger opening to bring the wire in because it is hidden from the general view.
If you must run the wire under the cabinet, it is a good plan to hide the wire by mounting the fixture as close to the rear of the cabinet as possible. Either way, once the wire is in place, wire up the fixture properly. Using screws that are short enough to not penetrate all of the way through the cabinet bottom, attach the fixture to the cabinet.
When the wire is completed, replace all covers on outlets and switches. Turn on the power and try out your new lighting. The difference should be a welcomed sight to you and anyone else who frequents the kitchen.
bra href=”http://remodelinggrandrapids.blogspot.com/”Remodeling Grand Rapids/a